Concentration, Brix value and Density measurement. If you want to use multiple measurements, this proven system is the optimal solution. It is composed of the three components evaluation unit (A), microwave module (B) and the probe (C). This configuration can be expanded to up to four measurements. Even with only two measuring points you'll reach significant cost savings. Nevertheless, with the modular design you remain extremely flexible.
Productspecifications
Housing Aluminium wall housing, protection IP65, Dimension 160 x 160 x 120 mm, 3,1 kg
Mounting 4 holding flaps H x B = 120 x 180 mm for ø 6 mm
Power supply 24 V DC, max. 1000 mA
Display 3.9”-Monochrome QVGA-LC, 320 x 240 pixel, illuminated. Large display of the measurement result and drag
pointer with analogue bar graph displays of deviation of the measurement in its definded scale
Microwave Extremely stabile phase, attenuation and level measurement with PLL-synthesizer, 2.45GHz, transmission performance
10 mW, 10 dBm
Microwave cable 2 x N-plugs for coaxial cable 50 ohms, typical 1 to 2 m (max. 3 m)
Handling Foil keyboard with 4 soft keys, well-structured multilingual
Status display LEDs for status of the measurement and access-PIN for parameter
Output 4 – 20 mA isolated output for concentration, load max. 500 ohms
Data interface USB 2.0 interface for software update, data output and calibration via pc
[PROFIBUS PA / ETHERNET/ IP / RS-232/-485 / CANopen – on request]
Data memory SD-/ SD-HC-Card Slot for writing/ reading measuring datas & storage set of parameters
Environment temperature 0 to 50°C
Temperature compensation Pt 100 with four-wire-system, M12 plug-in
Sample push-button for memorizing measured data, M12 plug-in
More information?
Contact us
